Skip to content
Let ideas be heard and improvements last.
Gemy

Risk assessment with 5×5 and Fine-Kinney

Finding and writing down hazards on the floor

Telling a hazard from a risk, walking the area with the team and writing each hazard as a row that can be scored.

Level:
Introductory
Who it is for:
Safety specialist, Shift supervisor
Duration:
1 min

In this lesson

  • Tell a hazard apart from a risk
  • Walk the area with the team in a set order
  • Write a hazard down so anyone can understand it

A hazard is something with the potential to cause harm: a rotating shaft, a raised platform, a chemical. In HSE's wording, a risk combines how likely that harm is with how serious it would be. The assessment starts by finding the hazard; a hazard nobody finds is never scored.

Split the area, then walk it

Split the area into parts by machine, job or zone. Walk each part together with the worker who does the job. Besides normal running, ask about maintenance, cleaning, setup and breakdowns.

  • Event, near-miss and first aid records show what has happened before.
  • Maintenance notes and breakdown records show the machine's weak points.
  • Noise, dust and lighting measurements show hazards the eye cannot see.

Write the hazard so anyone understands it

On each row write the hazard, who is affected and in which job it appears. A general row such as "machine hazard" cannot be scored. "Hand contact with the rotating chuck during setup" can be scored, and a control can be found for it.

Write today's controls on the same row. The first score is the raw risk as if there were no controls. The second is the residual risk that remains today, with those controls in place.

Check yourself

There is no score; tap a question to see the answer.

What is the difference between a hazard and a risk?

A hazard is the potential to cause harm; a risk combines how likely that harm is with how serious it would be.

Why ask about more than normal running?

During maintenance, cleaning, setup and breakdowns guards may be open; part of the hazard appears only then.

Related tool

Risk score: 5×5 matrix and Fine-Kinney

Sources

  1. Safety Management: Hazard Identification and Assessment, Occupational Safety and Health Administration (OSHA) (accessed 16 November 2026)
  2. İş Sağlığı ve Güvenliği Risk Değerlendirmesi Yönetmeliği (Resmî Gazete 29.12.2012, sayı 28512), T.C. Resmî Gazete (accessed 16 November 2026)
  3. Managing risks and risk assessment at work, Health and Safety Executive (HSE) (accessed 16 November 2026)

Cookies

Essential cookies are needed for the site to work. Analytics cookies load only if you allow them; declining is as easy as accepting. You can change your choice at any time via the footer link.

Cookie policyPrivacy notice