Skip to content
Let ideas be heard and improvements last.
Gemy

Tools

Calculate the risk score two ways

Choose the method, then mark the likelihood and impact; for Fine-Kinney choose the frequency as well. The tool shows the score, the level and the thresholds.

In short

The risk score calculator gives a score and level with the 5×5 matrix and the Fine-Kinney method. The steps and thresholds are Gemy's defaults; your company can define its own scale.

  • The calculation runs in your browser; nothing is sent
  • Every intermediate value is written with its formula under How was this calculated?
  • The result is a calculation that rests on the values you enter
  • The steps and thresholds are Gemy's default values

Calculate the risk score

Formula: Score = likelihood × impact

Sample values

Both methods are in one tool; the choice changes the score and thresholds.

A smaller value means less likely.

A smaller value means a milder outcome.

Result

Risk score
12
Level
High

How was this calculated?

  1. Score = likelihood 3 × impact 4 = 12
  2. Thresholds: medium from 5, high from 10, critical from 17; anything below is low.
  3. A score of 12 falls in the High level.

This is a calculation; it rests on the values you entered.

The steps and thresholds are Gemy's default values (ADR 0060). Your company can define its own scale, step names and thresholds. The default thresholds group the levels into four. The usual Fine-Kinney classification uses five bands, including 400 and above; common 5×5 classifications use different thresholds too. You can set your thresholds to match your own risk assessment table.

A score is not a decision: your company's risk rule and safety professional decide on controls and acceptability.

The calculation runs in your browser; the values you enter are not sent anywhere or stored.

For methodology training and preliminary calculation only; it does not replace an official risk assessment or notification.

Method and formula

A risk score combines how likely a hazard is and how serious its outcome would be in one number. The 5×5 matrix multiplies two factors; Fine-Kinney adds how often people are exposed. The score shows priority; your company's risk rule decides on controls and acceptability. Under Turkish Law No. 6331 the employer must carry out a risk assessment.

Formula: 5×5: score = likelihood × impact; Fine-Kinney: score = probability × frequency × severity. Gemy's risk management decision (ADR 0060); the scale steps and thresholds are the product's defaults.

Related term: read it in the glossary.

Sources

HSE (UK), managing risks and risk assessment at work.

ISO 31000:2018, risk management guidelines.

Occupational Health and Safety Law No. 6331 (Turkish legislation information system). Opens in a new tab (PDF).

How does it work in Gemy?

Gemy's risk module scores with the method the company chooses: 3×3, 5×5, Fine-Kinney or the company's own scale. The score's formula is written on the risk page; scale words and thresholds are company settings. Related product section.

Other calculators

Every calculator and template, from OEE to the risk score, on one page.

Cookies

Essential cookies are needed for the site to work. Analytics cookies load only if you allow them; declining is as easy as accepting. You can change your choice at any time via the footer link.

Cookie policyPrivacy notice