Catching failures early with FMEA
Setting the FMEA team and scope
Drawing the boundary of the study, forming the team and taking the rows from the process flow.
- Level:
- Introductory
- Who it is for:
- Quality engineer
- Duration:
- 1 min
In this lesson
- Write the start and end point of the study
- Form a team that knows the process
- Take failure mode rows from the process flow
The value of FMEA comes from the team thinking the process through together. A study with an unclear scope either never ends or skips important steps. So the first job is to draw the boundary.
Draw the boundary
Write where the study starts and where it ends: for example from material entering the cell to packing. A design FMEA deals with the functions of a product or part. Do not mix the two in one table.
Form the team
- An operator or shift supervisor who runs the process every day.
- Someone who knows the machine and its maintenance.
- Someone who knows quality and, where needed, the design or customer side.
Keep the team small and choose a facilitator. The facilitator asks the questions and reminds everyone of the shared scale when scoring.
Take the rows from the flow
Draw the process flow step by step and write what each step must do. Then ask of each step: how could it not be done, be done partly or be done wrongly? Each answer is a failure mode row.
Check yourself
There is no score; tap a question to see the answer.
What happens to an FMEA with an unclear scope?
It either never ends or skips important steps.
Where do failure mode rows come from?
From asking each step in the process flow how it could not be done or be done wrongly.
Sources
- IEC 60812:2018 Failure modes and effects analysis (FMEA and FMECA), International Electrotechnical Commission (IEC) (accessed 16 November 2026)
- Poka Yoke, Lean Enterprise Institute (accessed 16 November 2026)