Skip to content
Let ideas be heard and improvements last.
Gemy

Glossary

What is Calibration?

A short definition of Calibration, how it is applied on the floor and where it lives in the product.

Short definition
Calibration: Comparing the value a measuring device shows with a traceable reference and determining its deviation and uncertainty; adjusting the device and deciding conformity are separate steps.

How is it applied?

Every device is listed with its calibration interval and owner; an overdue device is withdrawn from use and the certificate is kept. Products measured with a device found far out are reviewed retrospectively. Fictional example: a calliper is compared with a reference gauge block, and the deviation and uncertainty found are written on the certificate. If the deviation exceeds the acceptance limit, the device is adjusted or withdrawn. Calibration is often confused with verification. Calibration determines the deviation; verification decides whether the device meets a given requirement. The calibration interval is set by how often the device is used and by its past results.

In the product

In the product the device list is kept with calibration and maintenance plans, work orders are opened and a device coming due is visible; rows are edited in the Excel view and the certificate is attached to the record.

Cookies

Essential cookies are needed for the site to work. Analytics cookies load only if you allow them; declining is as easy as accepting. You can change your choice at any time via the footer link.

Cookie policyPrivacy notice