Skip to content
Let ideas be heard and improvements last.
Gemy

Making management review useful

From a review decision to a tracked action

Writing a decision with its type, turning it into work followed with an owner and due date, and reading its status at the next meeting.

Level:
Practitioner
Who it is for:
Plant manager, Quality engineer
Duration:
1 min

In this lesson

  • Write a decision by its type
  • Turn a decision into work followed with an owner and a due date
  • Read the status of decisions at the next meeting

The output of a review is a decision. A meeting that ends without a written decision is an information session; it changes nothing in the system.

Write the decision with its type

  • Improvement opportunity: work that takes a process or service to a better place.
  • Change to the system: a change to a process, document, responsibility or objective.
  • Resource need: a need for people, equipment, budget or training.

Writing the type shows why the decision was taken. If decisions of the same type pile up over later meetings, that is an input too.

Owner and due date

Give each decision an owner and a due date. The owner is the person who follows the decision through; they do not have to do the work alone. Once the decision becomes a tracked action, its status is visible outside the meeting too.

Close the loop

The first item of the next meeting is the status of earlier decisions: done, in progress and overdue. For each overdue decision the reason and a new due date are discussed. For a finished decision, also check whether the work brought the expected result.

Check yourself

There is no score; tap a question to see the answer.

What does writing the decision type do?

It shows why the decision was taken; decisions of the same type that pile up become an input to the next review.

What is discussed for an overdue decision?

The reason for the delay and a new due date; if needed, the need for resources.

Sources

  1. ISO 9001:2026 Quality management systems, Requirements, International Organization for Standardization (ISO) (accessed 16 November 2026)
  2. Plan, Do, Check, Act (PDCA), Lean Enterprise Institute (accessed 16 November 2026)

Cookies

Essential cookies are needed for the site to work. Analytics cookies load only if you allow them; declining is as easy as accepting. You can change your choice at any time via the footer link.

Cookie policyPrivacy notice