From incident report to root cause
Root cause in incident investigation
Moving from the direct cause to the gap in the system and not stopping at human error.
- Level:
- Practitioner
- Who it is for:
- Safety specialist
- Duration:
- 1 min
In this lesson
- Separate the direct cause from the root cause
- Ask about the condition behind a human error
- Choose a measure that targets the root cause
The direct cause is what triggered the event just before it happened: a slipping foot, a guard left open. The root cause is the gap in the system that allowed that condition.
Do not stop at human error
"The worker was not careful" is a starting point, not a finding. Ask why care was needed, and why the job was so open to error. Fatigue, missing training, poor layout or conflicting instructions may lie behind it.
Keep asking why
Start from the direct cause and ask why again for every answer. Support each answer with a witness statement, a record or a condition seen in the area.
Tie the measure to the root cause
The measure should remove the root cause you found. A measure that removes the hazard at its source is stronger than a warning sign. Follow it for a while after applying it and check whether reports of the same kind go down.
- Write the direct cause and the root cause on separate lines.
- Write the role and the condition instead of a person's name.
- Name the owner of the measure and the follow-up period.
Check yourself
There is no score; tap a question to see the answer.
What is the difference between a direct cause and a root cause?
The direct cause triggers the event; the root cause is the gap in the system that allowed it.
Why is "the worker was not careful" not a finding?
It does not explain the condition that allowed it, such as fatigue, training, layout or instructions.
Related tool
Sources
- Incident Investigation, Occupational Safety and Health Administration (OSHA) (accessed 15 November 2026)
- Human factors in accident investigations, Health and Safety Executive (HSE) (accessed 15 November 2026)