Calibration and device tracking
What to do with a device that fails
Stopping the device, assessing past measurements and closing the record.
- Level:
- Practitioner
- Who it is for:
- Maintenance and calibration lead, Quality engineer
- Duration:
- 1 min
In this lesson
- Take a failed device out of use
- Identify the affected measurements
- Know the condition for returning the device to use
If the calibration report shows the device outside its acceptance limit, there are two jobs: stop the device and look back.
Stop the device
Take the device out of use straight away and put a visible mark on it. If there is a spare device, measurement continues with it.
Look back
List the measurements made with the device since its last passing calibration. Which products or batches were approved with them? Would the direction and size of the error change those decisions? Repeat doubtful measurements with another device.
Returning it to use
The device is adjusted or repaired and calibrated again. It returns to use only if the new result is within the acceptance limit. Write down the cause too, such as a drop, wear or misuse.
- Record the date it was stopped and who stopped it.
- Link the list of affected batches to the quality record.
- Review the calibration interval if failures recur.
Check yourself
There is no score; tap a question to see the answer.
What are the first two jobs for a device that fails?
Take it out of use and assess the measurements made since its last passing calibration.
When does the device return to use?
After adjustment or repair, when the new calibration result is within the acceptance limit.
Sources
- International Vocabulary of Metrology (VIM3), 2.39 calibration, Joint Committee for Guides in Metrology (JCGM) / BIPM (accessed 15 November 2026)
- International Vocabulary of Metrology (VIM3), 2.44 verification, Joint Committee for Guides in Metrology (JCGM) / BIPM (accessed 15 November 2026)
- NIST Policy on Metrological Traceability, National Institute of Standards and Technology (NIST) (accessed 15 November 2026)